A simple tool takes the guess work — and a lot of the brain work — out of making safe comfortable stairs.
Every time I’m asked to bid or to build a set of stairs, I unroll the
plans, look at the details, and shake my head. Architects rarely
include and often they don’t even have the basic information I need, the
few specifications that allow me to build a staircase that will meet
the stringent requirements of building code in my area.Before I can layout a set of stairs, I need to know the exact thickness of the finish floors, including the floors at the top of the stairs, at the bottom of the stairs, as well as on any intermediate landings. I also need to know the run of the stairs—exactly where the architect wants the stairs to start on the first floor and finish on the second, third, fourth, or fifth. And finally, I need to know the exact thickness of the finish treads. Once I have that information, I can make a story pole that allows me to build a stair with confidence that’s dead accurate, never once stopping to scratch my head over the calculations.
A story pole: Every measurement on a stick
Before I describe the layout process, I can’t stress enough the importance for every step of a staircase to be exactly the same height; a 1/4-in. difference between steps can be dangerous if not fatal. And with all the factors that go into a set of stairs, it’s very easy to make a mistake in layout or construction, which can throw off the consistency of the rises.As with all my finish carpentry, I follow two rules that make my staircases accurate and right: First, I design and layout the work completely before I build it. Second, I start with the finish and work back to the rough.
For complicated projects, a fullscale drawing or loft always works best. (I never depend on the architects 1/4-in. scale drawing—It’s not nearly accurate enough for stair building). But for most of the stairs I build, I just make a story pole, a crucial tool for precision stair building.
A story pole is basically a full-size elevation drawing shrunk down into one dimension—a line, in this case a 1×4 stick. I start by making field measurements, the first of which is the floor-to-floor height from where the stair will start—about the middle of the first riser location—to where the stair will end—about the middle of the top riser.
Credit by thisiscarpentry

No comments:
Post a Comment